xxoo
本帖最后由 time1200 于 2011-12-13 22:27 编辑Model Z17 Lens Replacement Kit
Operator's Manual
kit contents
*replacement lens
*rubber disk
*o-ring
installation
tools needed:hammer,flathead screwdriver with 1/4" tip, metal disk or nickel 本帖最后由 time1200 于 2010-9-24 21:28 编辑
1. place bezel on a hard flat surface with the lens end facing down.
position punch or screwdriver tip inside bezel at outer edge of the lens in an upright position.
one hard strike with a hammer will pop the lens out of the bezel 本帖最后由 time1200 于 2010-9-24 21:10 编辑
2.flip bezel onto opposite end and remove the old o-ring and replace with with new o-ring 本帖最后由 time1200 于 2010-9-24 21:16 编辑
3.peel off clear backing from the replacement lens and re position it slightly off-center (see illustration) 本帖最后由 time1200 于 2010-9-24 21:22 编辑
4.peel off white backing from the replacement lens and position lens onto bezel with the clear backing facing up.
place rubber disk onto center of lens (be sure it's on the clear backing) 本帖最后由 time1200 于 2010-9-24 21:28 编辑
5.set a nickle (or any metal disk of similar size) on top of rubber disk. place punch or screwdiver tip onto center of nickle or metal disk.
one hard strike with a hammer will pop the lens into place 本帖最后由 time1200 于 2010-9-24 21:51 编辑
SUREFIRE 6P BK 7777777777777777 {:1_270:}Thanks for TIME's sharing {:1_270:}Thanks for TIME's sharing
lunchen 发表于 2010-9-24 09:29 PM http://www.shoudian.org/images/common/back.gif 今天换了兩块........又收了支6PBK TIME又有新玩具入手了~我也要啦 TIME又有新玩具入手了~我也要啦
lunchen 发表于 2010-9-24 09:33 PM http://www.shoudian.org/images/common/back.gif是舊版的二手6P 恭喜TIME兄榮升少將了... 快上圖啊，不要賣關子 恭喜TIME兄榮升少將了...
tw_lolo 发表于 2010-9-24 09:38 PM http://www.shoudian.org/images/common/back.gifthank you 快快上图{:1_222:} http://www.shoudian.org/thread-145708-1-8.html 这个什么意思？ 在墙上投影出图像？ 最近收的都是老太婆{:1_254:} 最近收的都是老太婆{:1_254:}
xslwhwxh 发表于 2010-9-24 11:24 PM http://www.shoudian.org/images/common/back.gif還有一支金色的E2E等着我{:1_254:}
页:
[1]
2