TA的每日心情 | 开心 2015-4-26 16:15 |
---|
签到天数: 9 天 [LV.3]偶尔看看II
|
新手請教一下AW電池有甚麼過人之處, 謝謝 {:1_270:}
Beroro 发表于 2011-5-30 20:31
AW在CPF上对Protected R123A ( 750 mAH )的特点描述,英中对照(意译)。
New features :
新特性:
- High Current Threshold : they are good to run on high current draw incan lamps such as P90, TL-3, Strion and CA1499. They 'll even power up the Lumens Factory HO-9 ( 320 lumens ) and EO-9 ( 380 lumens ) on just 1 click ( use on EO-9 is not recommended ).
- 大电流极限: 在大电流驱动的白炽灯泡例如P90,TL-3,Strion和CA1499上使用很号,甚至于能一次点击驱动Lumens工厂的HO-9(320流明)和EO-9(380流明)(使用在EO-9上并不推荐)
- New Anti-expolsion Vent/PTC Module : the new module provides an added layer of protection against gas built-up in addition to the PTC thermal protection. Unlike regular vents used by most LiIon cells, these new modules will actually stop the action by separating the electrodes inside the battery when the pressure reaches a preset threshold. The vent disc will open and release the gas plus stopping the cell from further chemical reaction. Combined with the PCB electronic protection and two layers of mechanical ( thermal and pressure ) protection, these new protected R123s are the first with these added safey features in place.
- 新的防爆门/PTC热敏电阻模块:这个新的模块除了PTC热敏保护外提供了一个额外的气体相关保护层。不像一般用于锂电池的常规保护,这些新的模块会在气压到达一个预设的阈值时会分离电池内的电极从而实际有效中断反应。这些排泄孔会释放气体并停止电池进行进一步的化学反应。加上PCB电子保护和两层的结构(热的和压力的)保护,这些新的带保护的R123s是第一个采用这些新加安全措施。
Specifications :
- 750mAH
- 3.7V nominal
- 16.62mm ( diameter ) X 34.29mm ( length ) - +/- 0.1mm
- Overcharge protection at 4.35V(过充保护)
- Overdischarge protection at 2.45V(过放保护)
- short / over-current protection(短路、过电流保护)
- max. recommended continuous discharge rate @1.5A ( 2C )(最大的建议持续放电率)
不过体积比一般的16340要再粗壮些,当然感觉比较可靠耐用,特别是大电流安全使用。 |
|